Table of Contents
Advertisement
The parameters are as follows:
diagnostics
Checks all parts of the emulator configuration and reports any
inconsistencies. It identifies errors that result from inconsistencies between
related configuration values. These errors should be resolved in order for the
emulator to operate correctly.
This option primarily checks for inconsistencies between the mapper and the
EMSIM registers, but it also provides status messages about expectations and
limitations of the emulator of which you should be aware. (These checks are
primarily between the reset mode configuration value and the EMSIM
registers.)
If no messages are returned, no inconsistencies are found in the emulator
configuration.
sim_chip_selects
Display chip select information from the sim (processor) register set or the
emsim (emulator) register set. The resulting display shows:
emsim_chip
_selects
How the chip select is assigned.
The base address.
The block size.
Other information from the option register.
bus_interface_ports
Display bus interface information from the sim (processor) register set or the
emsim (emulator) register set. The resulting display shows the pin
embus_interface
assignments for the C, E, and F ports.
_ports
memory_map
When in the memory map section of the emulator configuration, the ranges of
memory that have been mapped are displayed.
The memory map configuration information shows detailed information about
the memory map and how actual mapper resources are allocated due to the
current programming of the chip selects in the EMSIM and EMRAM register
sets.
reset_mode
Displays information about the reset mode configuration value, whether it is
generated internally by the emulator or externally by the target system.
init_source_code
Displays the assembly language program that will initialize the processor as
defined by the current EMSIM register contents.
Emulator/Analyzer Interface Commands
display configuration_info
361
Advertisement
Table of Contents
