sequencer or trigger specification, any states given there are shown in the
trace list even if they don't meet the storage qualifier.
Examples
Trace only address 10h:
trace only address 10h
Trace only data value 0ffh:
trace only data 0ffh
Trace only write operations
trace only status write
To define a prestore qualifier
•
Place your prestore qualification into the entry buffer. Then choose
Trace→Only() Prestore.
•
Using the command line, enter commands as follows:
•
Specify a prestore qualifier by entering:
trace prestore <bus_state>
<bus_state> represents a combination of address, data and status
expressions that must be matched to satisfy the prestore qualifier.
•
Disable prestore qualification by entering:
trace prestore anything
Using the Emulation Analyzer
To define a prestore qualifier
217