Table of Contents
Advertisement
Using the Emulation Analyzer
To capture a continuous stream of program execution no matter how large your
program
Resume the program run from the point where it was interrupted
9
when the emulator broke to the monitor with the command run.
Wait until the notation "trig1 break" and/or "Emulation trace
10
complete" appears on the status line. Then store the new trace
memory content in a new file with commands like:
stop_trace
wait measurement_complete ; copy trace to <directory/filename+1>
Note that "filename+1" in the above command suggests use of consecutive
filenames to store your execution files, such as FILENAME1, FILENAME2,
etc.
Repeat steps 8 through 10 above until all program execution has been
captured. Your destination directory will have a set of files that, taken
together, contain all of your program execution. Note that if you did not
prevent capture of foreground monitor cycles in step 3 above, the last few
trace lines in each file may contain monitor cycles.
222
Advertisement
Table of Contents
