Table of Contents
Advertisement
Emulator/Analyzer Interface Commands
copy
printer
This option specifies your system printer as the destination device for the
copy command. Before you can specify the printer as the destination device,
you must define PRINTER as a shell variable. For example, you could enter
the text shown below after the "$" symbol:
$ PRINTER=lp
$ export PRINTER
If you don't want the print message to overwrite the command line, execute:
$ set PRINTER = "lp -s"
registers
Copies a list of the contents of the emulation processor registers to the
selected destination.
software
Copies a list of the current software breakpoints to a selected destination.
_breakpoints
status
Copies emulation and analysis status information.
to
This allows you to specify a destination for the copied information.
trace
Copies the current trace listing to the selected destination.
wait_for_exit
Waits for the UNIX command to complete before returning.
!
An exclamation point specifies the delimiter for UNIX commands. An
exclamation point must precede all UNIX commands. A trailing exclamation
point should be used if you want to return to the command line and specify
noheader. Otherwise, the trailing exclamation point is optional. If an
exclamation point is part of the UNIX command, a backslash (\) must
precede the exclamation point.
Examples
See the following pages on various copy syntax diagrams.
See Also
See the following pages on various copy syntax diagrams.
352
Advertisement
Table of Contents
