To Start A Trace Measurement - HP 64782 User Manual

For the graphical user interface

Hide thumbs Also See for 64782:

Table of Contents

Using the Emulation Analyzer

To start a trace measurement

Choose Trace→Everything.

Using the command line, enter:

When you use the trace command without any options, the analyzer begins

recording processor bus cycles immediately, and continues until the trace

buffer is filled. In the default trace configuration, the analyzer stores all bus

If you are using the deep analyzer, the depth of the trace list buffer depends

on whether or not you installed memory modules on the analyzer card, and

the capacity of the memory modules installed. Refer to the Hewlett-Packard

MC6833x Emulator/Analyzer Installation/Service/Terminal Interface

Guide for details. If you are using the 1K analyzer, the trace list buffer is 512

or 1024 states deep (depending on whether or not you turn on the state/time

count). See "To count states or time" in this chapter.)

From the demo directory /usr/hp64000/demo/debug_env/hp64749, start the

demo program and trace from the program start:

run from transfer_address