Table of Contents
Advertisement
To move through the trace list
•
Use the scroll bar at the right of the display to scroll up and down.
Use the arrows at the bottom of the display (if any) to scroll left and
right.
•
Using the command line, enter commands as follows:
•
To roll the trace display to the left, press <Ctrl>f simultaneously.
•
To roll the trace display to the right, press <Ctrl>g simultaneously.
•
To roll the display down one line, press the down arrow key.
•
To roll the display up one line, press the up arrow key.
•
To move to the previous page in the trace list, press the Pg Up or Prev key.
•
To move to the next page in the trace list, press the Pg Dn or Next key.
Though the trace display is set to 256 or more states, only 15 lines may be
displayed in the interface window, depending on your terminal type. You can
move through the trace list display using various key combinations.
You can roll the display left and right only if the trace list is wider than 80
columns. This may occur if you increased the width of the columns.
To disassemble the trace list
•
Choose Trace→Display Options... and in the dialog box, select
Data Format Mnemonic. Then click the OK or Apply pushbutton.
•
Use the mouse to place the cursor on a line in the trace list where
you want disassembly to begin. Then press the select mouse button,
and click on Disassemble From in the trace list popup menu.
•
Using the command line, enter commands as follows:
•
To disassemble instruction data in the trace list, enter:
display trace mnemonic
Using the Emulation Analyzer
To move through the trace list
235
Advertisement
Table of Contents
