Table of Contents
Advertisement
Installation
Step 3. Verify the software installation
Step 3. Verify the software installation
A number of new filesets were installed on your system during the software
installation process. This and following steps assume that you chose to load
the Graphical User Interface filesets.
You can use this step to further verify that the filesets necessary to
successfully start the Graphical User Interface have been loaded and that
customize scripts have run correctly. Of course, the update process gives you
mechanisms for verifying installation, but these checks can help to
double-check the install process.
Verify the existence of the HP64_Softkey file in the
1
/$hp64000/X11/app-defaults subdirectory by entering
ls /$hp64000/X11/app-defaults/HP64_Softkey at the HP-UX
prompt.
Finding this file verifies that you loaded the correct fileset and also verifies
that the customize scripts executed because this file is created from other
files during the customize process.
Examine /$hp64000/X11/app-defaults/HP64_Softkey near the end
2
of the file to confirm that there are resources specific to your
emulator.
Near the end of the file, there will be resource strings that contain references
to specific emulators. For example, if you installed the Graphical User
Interface for the 6833x emulator, resource name strings will have m6833x
embedded in them.
After you have verified the software installation, you must start the X server
and an X window manager (if you are not currently running an X server). If
you plan to run the Motif Window Manager (mwm), or similar window
manager, continue with Step 4a of these instructions. If you plan to run
HP VUE, skip to Step 4b of these instructions.
516
Advertisement
Table of Contents
