Table of Contents
Advertisement
Emulator/Analyzer Interface Commands
performance_measurement_initialize
performance_measurement_initialize
This command sets up performance measurements.
The emulation system will verify whether a symbolic database has been
loaded. If a symbolic database has been loaded, the performance
measurement is set up with the addresses of all global procedures and static
symbols. If a valid database has not been loaded, the system will default to a
predetermined set of addresses, which covers the entire emulation processor
address range.
The measurement will default to "activity" mode.
Default values will vary, depending on the type of operation selected, and
whether symbols have been loaded.
400
Advertisement
Table of Contents
