Table of Contents
Advertisement
Making Coordinated Measurements
To start synchronous measurements
Examples
To enable synchronous measurements:
specify run from 1e8h
To trace when synchronous execution begins:
specify trace after address main
To start synchronous measurements
•
Enter the cmb_execute command.
The cmb_execute command will cause the EXECUTE line to be pulsed,
thereby initiating a synchronous measurement. CMB interaction does not
have to be enabled in order to use either of these commands. (When you
enable CMB interaction, you only specify how the emulator will react to the
CMB EXECUTE signal.)
All emulators whose CMB interaction is enabled will break into the monitor
when any one of those emulators breaks into its monitor.
To disable synchronous measurements
•
Enter the specify run disable command.
You can disable the emulator's interaction with the CMB by using the
specify run disable command. When interaction is disabled, the emulator
ignores the CMB EXECUTE and READY lines.
312
Advertisement
Table of Contents
