Table of Contents
Advertisement
Installation
This chapter shows you how to install interface software. It also shows you
how to verify installation by starting the emulator analyzer interface for the
first time. These installation tasks are described in the following sections:
•
Where to find information on connecting the HP 64700 to a computer or
LAN.
•
Installing HP 9000 software.
•
Installing Sun SPARCsystem software.
•
Verifying the installation.
For information about installing hardware, refer to the MC6833x
Emulator/Analyzer Installation/Service/Terminal Interface User's Guide.
Minimum HP 9000 Hardware and System Requirements
The following is a set of minimum hardware and system recommendations for
operation of the Graphical User Interface on HP 9000 Series 300/400 and
Series 700 workstations.
HP-UX For Series 9000/300 and Series 9000/400 workstations, the
minimum supported version of the operating system is 7.03 or later. For
Series 9000/700 workstations, the minimum supported version of the
operating system is version 8.01.
Motif/OSF For Series 9000/700 workstations, you must also have the
Motif 1.1 dynamic link libraries installed. They are installed by default, so
you do not have to install them specifically for this product, but you
should consult your HP-UX documentation for confirmation and more
information.
Hardware and Memory Any workstation used with the Graphical
User Interface should have a minimum of 16 megabytes of memory.
Series 300 workstations should have a minimum performance equivalent
to that of a HP 9000/350. A color display is also highly recommended.
From here, you should proceed to the section titled "Installation for HP 9000
Hosted Systems" for instructions on how to install, verify, and start the
Graphical User Interface on HP 9000 systems.
510
Advertisement
Table of Contents
