Specify - HP 64782 User Manual

For the graphical user interface

Hide thumbs Also See for 64782:

Table of Contents

Emulator/Analyzer Interface Commands

specify

This command prepares a command for execution, and is used with the

cmb_execute command.

When you precede a run or trace command with specify, the system does

not execute your command immediately. Instead, it waits until until an

EXECUTE signal is received from the Coordinated Measurement Bus or until

you enter a cmb_execute command.

If the processor is reset and no address is specified, a cmb_execute

command will run the processor from the "reset" condition.

Note that the run specification is active until you enter specify run disable.

The trace specification is active until you enter another trace command

without the specify prefix.

The emulator will run from the current program counter address if no

address is specified in the command.

The parameters are as follows:

This option turns off the specify condition of the run process.