Table of Contents
Advertisement
The parameters are as follows:
address
Specifies an address for a temporary register breakpoint that will be
programmed into one of the processor's two breakpoint registers. Up to two
addresses may be specified.
--EXPR--
An expression is a combination of numeric values, symbols, operators, and
parentheses, specifying a memory address. See the EXPR syntax diagram.
FCODE
The function code used to define the address space being referenced. See the
syntax diagram for FCODE to see a list of the function codes available and for
an explanation of those codes.
from
This specifies the address from which program execution is to begin.
reset
This option resets the processor prior to running.
transfer_address
This represents the starting address of the program loaded into emulation or
target memory. The transfer address is defined in the linker map and is part
of the symbol database associated with the absolute file.
until
Causes a software breakpoint to be set at the specified address before the
program is run.
Examples
run
run from 810H
run from COLD_START
run from transfer_address until 910H
See Also
The step command.
Emulator/Analyzer Interface Commands
run
411
Advertisement
Table of Contents
