Table of Contents
Advertisement
Installation
Step 2. Set the necessary environment variables
Confirm that the tape drive BUSY and PROTECT lights are on. If the
4
PROTECT light is not on, remove the tape and confirm the position
of the write-protect screw. If the BUSY light is not on, check that the
tape is installed correctly in the drive and that the drive is operating
correctly.
When the BUSY light goes off and stays off, start the update program
5
by entering
/etc/update
at the HP-UX prompt.
When the HP-UX update utility main screen appears, confirm that the
6
source and destination devices are correct for your system. Refer to
the information on updating HP-UX in your HP-UX documentation if
you need to modify these values.
Select "Load Everything from Source Media" when your source and
7
destination directories are correct.
To begin the update, press the softkey <Select Item>. At the next
8
menu, press the softkey <Select Item> again. Answer the last prompt
with
y
It takes about 20 minutes to read the tape.
When the installation is complete, read /tmp/update.log to see the
9
results of the update.
Step 2. Set the necessary environment variables
The DISPLAY environment variable must be set before the Graphical User
Interface will start. Also, you should modify the PATH environment variable
to include the "/usr/hp64000/bin" directory, and, if you have installed
software in a directory other than "/", you need to set the HP64000
environment variable.
The following instructions show you how to set these variables at the UNIX
prompt. Modify your ".profile" or ".login" file if you wish these environment
variables to be set when you log in. The following instructions also assume
that you're using "sh" or "ksh"; if you're using "csh", environment variables are
set using the "setenv <VARIABLE> <value>" command.
514
Advertisement
Table of Contents
