Table of Contents
Advertisement
Error Messages
External label in use: <label> (1301)
Cause: This error occurs when you attempt to select the external analyzer's
independent state mode while an external trace label is currently used as a
qualifier in the emulation analyzer trace specification.
Action: Remove any external trace label qualifiers from emulation trace
specifications before selecting the external analyzer's independent state
mode.
Failed to disable step mode (684)
Cause: System failure.
Action: Run performance verification (Terminal Interface pv command).
Fatal error from function <ADDRESS OF FUNCTION>
Cause: This is an unexpected fatal system error.
Action: Cycle power on the emulator and start again. If this is a persistent
problem, call your HP 64000 representative.
FATAL SYSTEM SOFTWARE ERROR (204, 205, 208)
Cause: The system has encountered an error from which it cannot recover.
Action: Write down the sequence of commands which caused the error.
Cycle power on the emulator and re-enter the commands. If the error
repeats, call your local HP Sales and Service office for assistance.
File could not be opened
Cause: You tried to store or load trace data to a file with incorrect permission.
Or the analyzer could not find the file you specified, or else there were
already too many files open when you entered your command.
Action: Check the directory and file for correct read and write permission.
Specify a file that is accessible to the analyzer. Close the other files that are
presently open.
File perf.out does not exist
Cause: You tried to execute the "restore" command to continue a previous
software performance measurement, and the SPMT software found that no
"performance_measurement_end" command was previously executed to
create a file from which "restore" could be performed.
Action: Execute a new SPMT measurement.
460
Advertisement
Table of Contents
