Table of Contents
Advertisement
Error Messages
Configuration not valid, restoring previous configuration
Configuration not valid, restoring default configuration
Cause: The modifications you tried to make to the emulator configuration are
not valid, so the host system restored the previous configuration.
Action: See the "Configuring the Emulator" chapter for more information
about the emulator configuration items and their settings.
Configuration process QUIT
Cause: The configuration process ended because <CTRL> "\" (SIGQUIT
signal) was encountered. This is an easy way to exit configuration without
saving any changes.
Action: Try starting the emulation session again. If the problem persists, you
may need to cycle power on the emulator.
Connecting to <LOGICAL NAME>
Cause: This is a status message. The host system is making a communication
connection to the emulator whose logical name is defined in
/usr/hp64000/etc/64700tab.net or /usr/hp64000/etc/64700tab.
Continue load failed
Cause: The host system could not continue the previous emulation session
because it could not load the continue file.
Action: Try again. If the failure continues, call your HP Service
Representative.
Continuing previous session, continue file loaded
Cause: This is a status message. An emulation session which was ended
earlier with the end command has been restarted. The host system reported
that the session was continued (using settings from the previous session) and
that the continue file loaded properly.
Continuing previous session, user interface defaulted
Cause: The previous emulation session was continued and the Softkey
Interface was set to the default state.
453
Advertisement
Table of Contents
