Table of Contents
Advertisement
RANGE
The RANGE parameter allows you to specify a condition for the trace
measurement, made up of one or more values.
The range option can be used for state qualifier labels. Range can only be
used once in a trace measurement.
Refer to the "Qualifying Trigger and Store Conditions" section in the "Using
the Emulation Analyzer" chapter for a list of the predefined values that can
be assigned to the status state qualifiers.
Expression types are "address" when none is chosen.
The parameters are as follows:
address
The value following this softkey is searched for on the lines that monitor the
emulation processor's address bus.
data
The value following this softkey is searched for on the lines that monitor the
emulation processor's data bus.
--EXPR--
An expression is a combination of numeric values, symbols, operators, and
parentheses, specifying an address, data, status, or executed address value.
See the EXPR syntax diagram for details.
<external_label>
This represents a defined external analyzer label.
not
This specifies that the analyzer search for the logical "not" of the specified
range (this includes any addresses not in the specified range).
Emulator/Analyzer Interface Commands
RANGE
407
Advertisement
Table of Contents
