Table of Contents
Advertisement
end
This command terminates the current emulation session.
You can end the emulation session and keep the emulator in a locked state.
The current emulation configuration is stored, so that you can continue the
emulation session on reentry to the emulator. You also can release the
emulation system when ending the session so that others may use the
emulator.
Note that pressing <CTRL>d performs the same operation as pressing end
<RETURN>. Pressing <CTRL>\ or <CTRL>| performs the same as end
release_system <RETURN>.
When the emulation session ends, control returns to the UNIX shell without
releasing the emulator.
The parameters are as follows:
locked
This option allows you to stop all active instances of an emulator/analyzer
interface session in one or more windows and/or terminals. This option is not
available when operating the emulator in the measurement system.
release_system
This option stops all instances of the emulator/analyzer interface in one or
more windows or terminals. The emulation system is released for other
users. If you do not release the emulation system when ending, others
cannot access it.
Examples
end
end release_system
See Also
The "Exiting the Emulator/Analyzer Interface" section in the "Starting and
Exiting HP 64700 Interfaces" chapter.
Emulator/Analyzer Interface Commands
end
379
Advertisement
Table of Contents
