Table of Contents
Advertisement
Using the Emulation Analyzer
To display the trace list
Examples
To display the trace:
display trace
The first column in the trace list contains the line number. The trigger is
always on line 0.
The second column contains the address information associated with the
trace states. Addresses in this column may be locations of instruction
opcodes on fetch cycles, or they may be sources or destinations of operand
cycles.
The third column shows mnemonic information about the emulation bus
cycle.
The next column shows the count information (time is counted by default).
"Relative" indicates that each count is relative to the previous state.
If your analyzer card contains external analysis (for example, HP 64703), the
next column shows the data captured on the external trace signals.
You can use the <NEXT> and <PREV> keys to scroll through the trace list a
page at a time. The <Up arrow> and <Down arrow> keys will scroll through
the trace list a line at a time. You can also display the trace list centered
around a specific line number (for example, display trace 100). Refer to
the "Modifying the Trace Display" section for more information on the trace
list display.
198
Advertisement
Table of Contents
