Table of Contents
Advertisement
Emulator/Analyzer Interface Commands
load
emul_mem
Loads only those portions of the absolute file that reside in memory ranges
mapped as emulation memory.
FCODE
Specifies the address space where the file will be loaded.
fg_mon
Loads a foreground monitor.
<FILE>
This represents the absolute file to be loaded into either target system
memory, emulation memory (.X files are assumed), or the trace memory (.TR
files are assumed).
offset_by
Specifies an offset value that is subtracted from the address before the
<OFFSET>
foreground monitor file is loaded.
noabort
This option allows you to load a file even if part of the file is located at
memory mapped as "guarded" or "target ROM" (trom).
nosymbols
This option causes the file specified to be loaded without symbols.
noupdate
This option suppresses rebuilding of the symbol data base when you load an
absolute file. If you load an absolute file, end emulation, then modify the file
(and relink it), the symbol database will not be updated upon reentering
emulation and reloading the file. The default is to rebuild the database.
symbols
This option causes the file specified to be loaded with symbols.
trace
This option allows you to load a previously generated trace file.
trace_spec
This option allows you to load a previously generated trace specification.
Note that the current trace specification will be modified, but a new trace will
not be started. To start a trace with the newly loaded trace specification,
enter trace again or specify trace again (not trace). If you specify trace, a
new trace will begin with the default trace specification, not the one you
loaded.
user_mem
Loads only those portions of the absolute file that reside in memory ranges
mapped as target memory.
Examples
load sort1
load configuration config3
See Also
The display trace command.
388
Advertisement
Table of Contents
