HP 64782 User Manual page 402

The parameters are as follows:
activity
This option causes the performance measurement process to operate as
though an option is not specified.
duration This option sets the measurement mode to "duration." Time ranges will
default to a predetermined set (unless a user-defined file of time ranges is
specified).
<FILE>
This represents a file you specify to supply user-defined address or time
ranges to the emulator.
global_symbols
This option specifies that the performance measurement will be set up with
the addresses of all global symbols and procedures in the source program.
local_symbols_in This causes addresses of the local symbols to be used as the default ranges
for the measurement.
restore This option restores old measurement data so that a measurement can be
continued when using the same trace command as previously used.
--SYMB--
This represents the source file that contains the local symbols to be listed.
This also can be a program symbol name, in which case all symbols that are
local to a function or procedure are used. See the SYMB syntax diagram.
Examples performance_measurement_initialize
performance_measurement_initialize duration
performance_measurement_initialize
local_symbols_in mod_name
See Also The performance_measurement_run and
performance_measurement_end commands.
Refer to the "Making Software Performance Measurements" chapter for
examples of performance measurement specification and use.
Emulator/Analyzer Interface Commands
performance_measurement_initialize
401