Limitations, Restrictions; Foreground Monitor; Monitor Break At Sleep/Standby Mode; Store Condition And Trace - HP 64793 Series User Manual

Limitations,
Restrictions

Foreground Monitor

Monitor Break at
Sleep/Standby Mode
Store Condition and
Trace
Step Command and
Interrupts

RAM Enable Bit

Software
Performance
Measurement
1-6 Introduction to the H8/338 Emulator
Foreground Monitor is not supported for the H8/338 emulator.
When the emulator breaks into the emulation monitor, sleep or
software standby mode is released.
Disassembling of program execution in the trace list may not be
accurate when the emulation analyzer is used with store condition.
Refer to chapter 2 of this manual for more information.
Step execution cannot be performed in the following cases.
When the emulator is in the monitor and a suspended interrupt
is existed.
When the emulator is in the monitor and a level sensed
interrupt is existed (including interrupts from internal I/O
device).
Refer to Chapter 5 of this manual.
The internal RAM of H8/338 processor can be enabled/disabled by
RAME (RAM enable bit). However, once you map the internal RAM
area to emulation RAM, the emulator still accesses emulation RAM
even if the internal RAM is disabled by RAME.
Program Activity Measurement using the Software Performance
Measurement Tool (SPMT) is valid only for H8/338 internal ROM
area. (that is, 0 hex through 3fff hex.) Outside this area, the result of
Program Activity Measurement is not reliable