Table of Contents
Advertisement
Error Messages
Emul700dmn executable not found
Cause: The emulation session could not begin because the host system could
not locate the HP 64700 emulator daemon process executable.
Action: Make sure that software installation is correct. Then try starting the
emulator again.
Emul700dmn failed to start
Cause: The emulation session could not begin because the host system could
not start the HP 64700 emulator daemon process.
Action: Make sure there is sufficient disk space under /usr/hp64000. Make
sure the host system is operating properly, that all Softkey Interface software
has been loaded correctly, and the data communication switch settings on
the emulator rear panel match the settings in the
/usr/hp64000/etc/64700tab.net (or 64700tab) file.
Emul700dmn message too large
Emul700dmn message too small
Emul700dmn queue and/or semaphores missing
Emul700dmn queue failure
Emul700dmn error in file operation
Emul700dmn queue full
Cause: The HP 64700 emulator daemon process command was too large for
the host system to process.
Action: You must press end_release_system to exit this emulation session
completely; then start a new session. Make sure the host system is operating
properly, that all Softkey Interface software has been loaded correctly, and
the data communication switch settings on the emulator rear panel match the
settings in the /usr/hp64000/etc/64700tab.net (or 64700tab) file. You may
have to cycle power and use emul700 -u ,logical name> to unlock the system.
Emul700dmn sem op failed, perhaps kernel limits too low
Cause: The host system could not start the emulation session; there may be
too many processes running on the host system.
Action: Make sure the host system is operating properly, and is not
overloaded with currently executing processes. Stop or remove some
processes on the system. Also, verify that the semaphore capabilities have
been installed in the UNIX kernel. Then try starting the emulation session
again.
457
Advertisement
Table of Contents
