HP 64782 User Manual page 455

Error Messages
Could not create <CONFIGURATION BINARY FILENAME>
Cause: The system could not create a binary emulation configuration file
(file.EB).
Action: Check the file.EB write permission and verify that the specified
directory exists and is writeable.
Could not create default configuration
Cause: The host system could not create a default configuration for the
emulation session.
Action: Check disk space under /usr/hp64000 and verify proper software
installation.
Could not exec configuration process
Cause: The host system could not fork the configuration process or could not
execute the configuration process.
Action: Make sure that the host system is operating properly, and that all
Softkey Interface files were loaded properly during the installation process.
Try starting the emulation session again.
Could not load default configuration
Cause: The host system could not load the default configuration into the
emulator.
Action: Cycle power on the emulator and run the Terminal Interface "pv"
(performance verification) command on the emulator to verify that it is
functioning properly. Also, verify proper software installation. If loading
default configuration still fails, then call your HP 64000 representative.
Count out of bounds: %s (318)
Cause: You specified an occurrence count less than 1 or greater than 65535.
Action: Re-enter the command, specifying a count value from 1 to 65535.
Coverage commands not allowed when tag mode enabled (149)
Cause: When tag memory is enabled, coverage commands are disabled.
454