Table of Contents
Advertisement
Error Messages
Software breakpoint: %s (615)
Cause: This status message will be displayed if a software breakpoint is
encountered during a program run. The emulator is broken to the monitor.
The string %s indicates the address where the breakpoint was encountered.
Software breakpoint break condition is disabled (661)
Cause: You have attempted to set or clear a software breakpoint when
software breakpoints are disabled.
Action: You must enable software breakpoints before you can set them.
Specified breakpoint not in list: %s (663)
Cause: You tried to clear a software breakpoint that was not previously set.
The string %s prints the address of the breakpoint you attempted to clear.
Action: You must first set a software breakpoint before it can be cleared.
Starting address greater than ending address
Cause: You specified a starting address that is greater than the ending
address.
Action: Specify a starting address that is less than or equal to the ending
address.
Starting new session, continue file loaded
Cause: This is a status message. The emulator was started using a new
emulation session, and the continue file loaded properly.
Starting new session, user interface defaulted
Cause: The emulator was started using a new emulation session, and the user
interface was set to default selections.
Action: Call your HP Service Representative.
Status unknown, run "emul700 -l <LOGICAL NAME>"
Cause: The host system cannot determine the status of the emulator.
Action: To verify communication between the emulator and the host system,
and display the emulator status, enter the emul700 -l <logical name>
command. The emulator logical name is located in the
/usr/hp64000/etc/64700tab.net (or 64700tab) file.
478
Advertisement
Table of Contents
