Job Aid: Replacing the S8300 Server or its hard drive
This job aid describes the procedures to replace an installed S8300 Server or its hard drive.
This section contains procedures to:
Replace an S8300B server with an S8300B Server.
●
Replace an S8300B hard drive.
●
Replace an S8300C server with an S8300C Server (SES not enabled)
●
Replace an S8300D server with an S8300D Server (SES not enabled)
●
Replace an S8300C or S8300D Server hard drive (SES not enabled)
●
To replace an S8300C or S8300D Server with SES enabled, see
Communication Manager and co-resident SES: Replacing the S8300C or S8300D Server or
hard drive
on page 19.
Note:
In this Job Aid, the term S8300 hardware refers to:
Note:
- the S8300D Server (Material ID 700447675) including its 160 GB hard disk drive
- the S8300C Server (Material ID 700407810) including its 40 GB hard disk drive
- the S8300B Server (Material ID 700394810) including its hard disk drive
!
Important:
Always check the Avaya Support Web site for Product Correction Notices at
Important:
http://support.avaya.com
products) in the MOST POPULAR PRODUCTS IN SUPPORT section.
Note:
The Avaya S8300D Server will be available after May 2009.
Note:
Assumptions
The following items are assumed for the successful completion of this replacement procedure. If
any of these assumptions do not apply to your scenario, some steps in the on-site replacement
procedures may need to be modified:
The existing S8300 hardware may or may not be functional.
●
The S8300 may be configured as a primary controller or as an LSP.
●
The following information is available:
●
and select Product Correction Notices (All Avaya
Job Aid: S8300
03-300528 Issue 6 May 2009
1