Table of Contents
Advertisement
Operation
Error Handling
General
1. Remove errors if the cause is known
2. Touch Clear if this button is shown
3. If required, touch the Stop key on the
screen, wait until the paper transport of the
Printer is empty and then press Reset.
The screen remains grey during the Reset
procedure. Duration approx. 3 minutes.
4. If the message Reset successful appears,
the work can be continued, if not, other ac-
tions must be taken.
In case of unrepaired Errors
Call up the error list:
All error messages in the status line are saved.
They can be called up with the fixed buttons
The list shows the error messages with date and
time of the occurrence of the error.
− If an error of the Paper Processor has not
been removed, mark the error message and
touch Cancel selection
− Messages of the Printer mainly concern pa-
per that has to be removed.
Remove the paper
− Deactivate Show all errors so that only ac-
tive errors are displayed. All active errors
must be removed and deleted from the list
with Cancel selection.
− If after this, the machine does not perform a
Reset automatically, exit the error list and
trigger the Reset by hand
− If the Reset is unsuccessful, this message
covers all relevant error message. To make
them visible again, open one of the front
doors: The large error Popups are displayed
again.
− If the loop – constantly unrepaired errors –
cannot be interrupted, push the ON key.
AGFA d-lab.3
Deviations from normal Operation
.
i
2003-06-01 /PN 9008
062
7.5
Advertisement
Table of Contents
