Table of Contents
Advertisement
Operation
Manual Positioning
In this print mode the preview function is always
used.
Index prints and packages are not possible with
Manual positioning.
Print mode for all orders that cannot be handled in
the Autoprint or Reorder mode:
– Films / film strips
− without extended DX code
− DX code illegible (space detection not
possible in TFS / APL)
– single frames (max. 2 negatives)
– Call up:
Print mode
Manual positioning
The Prescanner is calibrated: Duration about
5 seconds. Do not remove the film carrier
during this time!
– If required, touch Change configuration to
change the configuration temporarily for the
whole order. After inserting a film or single
negative, this button can only be used to enter
modifications for the current image.
– Insert the negative(s):
− Insert film strips / whole films in the film
feeder: They are pulled in, scanned, and
positioned on the film tip.
− Single negatives: Pull out the film carrier,
put in the negative, push in the film carrier.
st
The 1
frame of the film strip is displayed; of a
single negative, only the scanned part of the
piece of film is shown. It must then be
positioned correctly.
AGFA d-lab.3
2003-06-01 /PN 9008
Production
013
6.37
Advertisement
Table of Contents
