Table of Contents
Advertisement
Introduction
For the Operation
Do not operate the machine without the covers
and panels. Persons who open or remove covers
expose themselves to dangerous voltages or run
other risks.
Do not cover or block the venting openings in the
housing: This may lead to overheating of single
components.
No objects or liquids should get into the machine
through the venting openings: This may cause fire
or electric shocks.
Do not squeeze the power cable and install it in
such a way that no one can step on the cable.
Avoid excessive generation of dust as this may
damage the components in the machine.
For Service / Repair Work
− Please respect the local safety precautions
− Be sure to switch off the machine before
service and repair jobs are performed
− The machine is equipped with high-voltage
carrying and fragile components. For this
reason, the following jobs must only be
performed by authorised service technicians:
− Repairs on electrical components
− Maintenance jobs / removal of parts and
covers not described in this documentation
− Use original Agfa spare parts: Only these parts
have been tested for their safety and usability
− When replacing electrical components:
Observe the data given in the circuit and wiring
diagrams.
− At the end of all service / maintenance jobs:
Check the general function of the machine as
well as the correct condition of the safety
devices.
For the Disposal of the Machine
The machine must be disposed of as industrial
waste.
1.4
2003-06-01 /PN 9008
Operation
AGFA d-lab.3
Advertisement
Table of Contents
