Selector Logic (Only For Color Negatives); Tfs Selector - AGFA d-lab.3 Technical Documentation Manual

Operation

Selector Logic (only for color negatives)

TFS Selector

The button TFS Selector is only accessible after
the Selector logic has been activated.
This function should always be activated, and
should only be switched off for special test
purposes, e.g. test of the mixed printing.
Note:
Certain parts of the logic are effective even if the
regulators have not been changed.
Recommendation:
Do not change the standard setting.
The selector logic recognizes films that can be
classified acc. to certain exposure failure
categories.
Standard setting:
Step width:
Information regarding selector 4:
Skips stickers (twin check labels) on the film.
The parameter should be adjusted in such a
way that the negative with the sticker is not
printed.
Parameters Skips
Selector 1 Underexposed negatives
Selector 2 Overexposed negatives
Selector 3 Fogged or partly blackened
negatives (e.g. light leaking
into an opened camera)
Selector 4 Sticker detection on the film
(twin check label)
AGFA d-lab.3
1.0
0.1
Range Description
0.0 - +4.0 Towards 0.0 more underexposed
negatives are printed
Towards +4.0 fewer underexposed
negatives are printed
-4.0 - +4.0 Towards –4.0 more overexposed
negatives are printed
Towards +4.0 fewer overexposed
negatives are printed
-4.0 - +4.0 Towards -4 more negatives with this
problem are printed, towards +4 less
negatives with this problem are
printed
-4.0 - +4.0 Towards -4 more negatives with
stickers are printed, towards +4 less
negatives with stickers are printed
2003-06-01 /PN 9008
Settings
079
098
4.43