Plug & Play Installation Manual
The Plug & Play Manual is intended for both the printers with one and with
two trays.
The operation is identical for each input tray.
Topics:
•
Contents of the packages
•
Remove the packing materials
•
Remove the printer from the pallet
•
Unpack the accessories
•
Environment specifications
•
Remove the transport protections
•
Connect the cables
•
Verify film position tabs
•
Load film in the input trays
•
Startup the printer
•
Configure network settings
Drystar 5301, Drystar 5302 | Plug & Play Installation Manual | 129
Note: This manual only deals with the printer equipped with two
trays. As the operation of the lower input tray is identical to the
upper input tray, this manual is also applicable for the printer
equipped with one tray.
Note: The device must only be operated according to its
specifications and its intended use. Any operation not
corresponding to the specifications or intended use may result
in hazards, which in turn may lead to serious injuries or fatal
accidents (for example electric shock). AGFA positively will not
assume any liability in these cases
Note: The device must only be installed and put into operation
under the specified conditions. For more information about
safety, security and use, refer to the Reference and User manual.
2831F EN 20210601 1655