140 | DRY 3.4 | Plug & Play Installation Manual
Plug & Play Installation Manual
The Plug & Play Manual is intended for both the printers with two and with
three trays.
The operation is identical for each input tray.
Topics:
•
Contents of the packages
•
Remove the packing materials
•
Remove the printer from the pallet
•
Unpack the accessories
•
Environment specifications
•
Remove the protection straps
•
Mount Drum belt
•
Install output trays
•
Connect the cables
•
Startup the printer
•
Verify film position tabs
•
Load film in the input trays
•
Configure network settings and print test images
2602A EN 20191018 0826
Note: This manual only deals with the printer equipped with two
trays. As the operation of the Middle input tray is identical to the
Upper and Lower input tray, this manual is also applicable for
the printer equipped with three trays.
Note: The device must only be operated according to its
specifications and its intended use. Any operation not
corresponding to the specifications or intended use may result
in hazards, which in turn may lead to serious injuries or fatal
accidents (for example electric shock). AGFA positively will not
assume any liability in these cases
Note: The device must only be installed and put into operation
under the specified conditions. For more information about
safety, security and use, refer to the Reference and User manual.