User Programmable Functions - Interlogix Advisor Advanced ATS 000A Series Installation And Programming Manual

User programmable functions

You can program your own user functions that can later be activated
automatically or manually. For example, you can program a user function for
setting an area or switching on an output, and then define a schedule for it.
Programming menu
The function programming menu is accessible from various menus where user
programmable functions are used.
The list of allowed functions may vary for different menus.
To program a user function:
1 Type
>None<
First, choose an appropriate function type using submenu 1.
Next, configure function parameters in submenu 2.
Available parameters depend on the selected function type. For particular types
submenu 2 is disabled.
Note: Particular functions require user code entering. To disable it, switch off the
"User Code Req" parameter, if allowed.
Depending on the activation method, the following function types and parameters
may be available.
Table 37: Available function types and parameters
Type Description
None No function is assigned
Set Set areas [1][2]
Unset Unset areas [1]
Trigger Change a trigger state
Part set 1 Part set 1 for areas [1][2]
Part set 2 Part set 2 for areas [1][2]
Inhibit Inhibit zones [1][3]
Test call Execute a test call [3][4]
PC connection Establish connection with the PC
[1][3]
Service in Allow service in [5]
Panic Activate panic alarm
Advisor Advanced ATSx000A(-IP) Installation and Programming Manual
Available parameters
None
1. Areas selection
2. User code requirement
1. Areas selection
1. Trigger name
2. State change: Clear, Set, or Toggle
1. Areas selection
2. User code requirement
1. Areas selection
2. User code requirement
None
None
None
None
None
193