Siren Connection; Other Connections - Interlogix Advisor Advanced ATS 000A Series Installation And Programming Manual

Siren connection

Figure 18: Siren connection examples
(1) Siren EOL resistor (1 kΩ). It must be
installed if siren does not contain a
built-in resistor.
(2) Siren.
Note: Siren output can be configured as internal or external. This is accomplished via panel
settings, not by configuring the panel hardware. See "Default output assignments" on page 23
and "Filters, outputs, and triggers" on page 116.

Other connections

Tamper connection
Figure 19: Earthing, external tamper, and PSTN connection in ATSx000A(-IP)
Tx
PSTN connection
For ATSx000A(-IP), refer to Figure 19 above.
20
S3 S4 S5 S1 C S2 C
LC-OUTPUTS HC-OUTPUTS
(1) (1)
(3)
(2) (2)
(3) Beacon, maximum 50 mA.
(4) Siren tamper EOL resistor.
(5) Siren tamper (normally closed).
(1)
(2)
(3)
(4)
( ) 5
Advisor Advanced ATSx000A(-IP) Installation and Programming Manual
T C - -
SIR TMP AUX POWER
(4)
(5)
(1) Phone (switched)
(2) PSTN line
(3) Earthing
(4) External tamper (normally closed)
(5) Optional pry-off tamper (normally
closed) required by EN 50131
Grade 3 and VdS-C regulations