Interlogix Advisor Advanced ATS 000A Series Installation And Programming Manual page 151

8.1.3.6 Installer in-time
6 Inst in-time
>00:01'00<
The Installer in-time menu allows you to configure the time in which an engineer
is allowed to access when granted by a user (see "8.2.1 User code required" on
page 143). This time starts when the user activates the option "Installer in".
During this time the installer can enter the installer menu and set or unset the
system.
When the installer is in the installer menu, this time has no effect on how long the
installer can stay logged.
The allowed range is 00 h 01 min to 11 h 59 min. A value of 12 h 00 min is
equivalent to infinite access.
8.1.4 Zone timer menu
1>DblKnock int
10'00
The Zone timer menu allows you to set up all programmable zone timers.
8.1.4.1 Double knock interval
1 DblKnock int
>00'00<
If enabled for a particular zone, Double knock interval specifies the maximum
permitted time between two pulses that will register an alarm. If this value is set
to 0, an alarm condition is not determined by the interval between two pulses, but
determined solely by Double knock open time. The allowed range is 0 to
15 minutes.
8.1.4.2 Double knock open
2 DblKnock open
>00'05<
If enabled for a particular zone, Double knock open specifies the time for which
the zone may remain active. If the zone remains active after this time exceeded,
an alarm is generated without waiting for a second activation.
The input format is mm'ss. The allowed range is from 00'00 to 15'00.
8.1.4.3 Soak test
3 Soak test
> <
The Soak test option defines the number of days the soak test for a zone is
active. The allowed range is 0 to 30 days.
Soak test is activated as soon as the zone option Soak test (see "4.1.n.6.9 Soak
test" on page 98) for a zone has been set to Yes. During the soak test period the
zone does not trigger alarms.
Advisor Advanced ATSx000A(-IP) Installation and Programming Manual 141