Table of Contents
Advertisement
Programming sequence
Advisor Advanced control panels feature a wide range of options designed to
match varied requirements. This versatility makes correct configuration more
demanding. It's important that you use a structured and controlled approach
when programming Advisor Advanced systems.
Basic setup
The basic setup covers all settings needed to put an Advisor Advanced control
panel into operation with the most common programming.
1. Draw the floor plan and label all zones, equipment, areas etc. Use
programming sheets to fill out all information.
2. Perform the initial installation of the control panel (see "Initial start-up" on
page 43).
3. Change the installer code using user menu "1.4 Change PIN" (see page 64).
4. Set the correct time and date using menu "8.1.1 Time and date" (see
page 138).
5. Program the area options like Area names and entry/exit times using menu "5
Area menu" (see page 113).
6. Use "2.1 Installed remote devices" to enable any keypad or expander
connected on the bus.
7. If necessary, configure additional details for keypads using menu "2.2.1
Keypad devices" (see page 68).
8. If necessary, configure additional details for expanders using menu "2.2.2
Expander devices" (see page 75).
9. Program the necessary system-wide input settings using menu "8.5 Zone
options" on page 152.
10. Program the necessary zone details like zone type, zone name and reporting
options using menu "4 Zones and RF fobs" (see page 94).
11. Program the central station and communications details using menu "9 Dialler
menu" (see page 162).
12. Map events to outputs as required using menu "6 Outputs and filters" on page
116.
Advanced setup
The steps given in "Basic setup" above are required for all systems. The
following additional steps may be required for advanced installations.
1. Program additional system options using menu "8 System option menu" (see
page 138).
Advisor Advanced ATSx000A(-IP) Installation and Programming Manual
33
Advertisement
Table of Contents
Troubleshooting
