Table of Contents
Advertisement
Note:
When the system performs an automatic account check, the response is
treated as an SMS from an unauthorized source, and therefore is forwarded to
the Supervisor. Please make sure that option "9.3.n.6.2 SMS forwarding" on
page 183 is enabled, otherwise the account state response will be lost.
9.3.n.5.3.6 Check time
6 Check time
>12:00<
The Check time is the time of day in 24 h format when the system performs the
automatic account check described in "9.3.n.5.3.5 Check period" on page 181.
9.3.n.5.4 Jamm detection
1>Jamm detection
Off
The menu allows you to configure GSM jamming detection parameters.
9.3.n.5.4.1 Jamm detection
1 Jamm detection
>Off<
If set to On, the panel raises tamper alarm when GSM jamming is detected.
Note:
The dialler must support jamming detection functionality. The detection is
supported in the ATS7310 GSM dialler with firmware version V01.08 or later.
9.3.n.5.4.2 Jamming threshold
2 Jamm threshold
>20<
Configure the threshold for jamming detection report. The allowed range is
from 1 (−111 dBm) to 31 (−51 dBm). The default value is 20 (−73 dBm).
9.3.n.6 SMS Setup
1>SMS Center num
None
The SMS Setup menu lets you change various SMS settings.
9.3.n.6.1 SMS Center num
1 SMS Center num
>
<
The SMS Center number is the access number for the SMS service.
If this value is empty, the system uses the default number stored in the SIM card.
Use this menu to enter a number other than the provider's default one.
Caution:
Delete this number before changing the SIM card. Otherwise, the
system will overwrite the default SMS center number on the new SIM card with
this number.
182
Advisor Advanced ATSx000A(-IP) Installation and Programming Manual
Advertisement
Table of Contents
Troubleshooting
