Interlogix Advisor Advanced ATS 000A Series Installation And Programming Manual page 159

8.4.1 RTS options
1>Zone alarm
Yes
The RTS options menu defines conditions that can prevent setting. If a particular
condition below has this option set to Yes, its state affects the "Ready To Set"
state. The system does not allow for areas to set if any of the conditions are true.
For conditions related to areas, the condition is tested for those areas. For
example Zone 5 assigned to area 1 only affects the setting of area 1.
Table 33: Ready To Set conditions
Condition
8.4.1.1 Zone alarm
8.4.1.2 Zone panic
8.4.1.3 Zone masking
8.4.1.4 Zone fault
8.4.1.5 Zone tamper
8.4.1.6 Interconnection fault
8.4.1.7 Mains fault
8.4.1.8 Battery fault
8.4.1.9 FTC (Failed to Communicate)
8.4.1.10 Siren fault
8.4.1.11 Zone technical
8.4.1.12 Keypad fault
8.4.1.13 Expander fault
8.4.1.14 Comms fault
8.4.1.15 Engineer reset
8.4.1.16 Alarms pending
8.4.2 Inhibit includes
1>Zone panic
Access level 3
The menu defines which conditions a user with particular access level is allowed
to inhibit. If a particular condition below has this option set to Access level 2 or
Access level 3, a user with this access level can inhibit it using an inhibit menu or
during set.
Table 34: Inhibit inclusion options
Condition
8.4.2.1 Zone panic
8.4.2.2 Zone masking
Advisor Advanced ATSx000A(-IP) Installation and Programming Manual
Description
Active zone
Hold-up device active
Masking / fault state on input
Intrusion detector fault
Tamper in zone
A critical error caused by communication trouble
between internal panel components
Mains fault, including external fault
Battery fault, including external fault
Alarm reporting has failed to deliver events
Siren output fault
An alarm in the technical zone
A fault reported by keypad
A fault reported by remote expander
All transmission paths are down (no communication)
Engineer reset requirement
Unacknowledged alarms
Description
Holdup device active
Masking / fault state on input
149