Interlogix Advisor Advanced ATS 000A Series Installation And Programming Manual page 60

•
Exit output test. On exit, the output returns to its original state. Press Clear.
1.2.3.1.2 Keypad LEDs
1>Keypad 1
2 Keypad 2
Use the Keypad LEDs menu to test keypad and reader LEDs.
Choose the keypad and press Enter.
You can now:
•
Switch all keypad LEDs to the on or off state using the Enter button.
•
Exit keypad LED test. Press Clear to exit from test and restore the LED
states.
1.2.3.2 Trigger state
1>Trigger 1
2 Trigger 2
The trigger state menu allows you to manually change trigger flag states.
Choose the trigger and then choose the appropriate flag. Next, set the required
state.
1>SCHEDULE
Off
1.2.4 Alarms and faults
0>All
1 Area 1
The Alarms and faults menu provides an overview of all zones that are not in
normal state and all faults present in the system. All items scroll automatically.
You can view a single area or all areas together.
Use the Clear or Enter button to exit this view.
1.2.5 Walk test
1>Start
2 Walk test opts
The Walk test menu allows testing of zones. The zone passes the test when
switching its state from normal to active, and then from active to normal. In walk
test mode each zone state change is signalled by the keypad buzzer or an
internal bell.
This menu allows you to run the test manually (engineer walk test), as well as
define conditions when the user has to perform the walk test, including a required
walk test before setting an area (user walk test).
50 Advisor Advanced ATSx000A(-IP) Installation and Programming Manual