Interlogix Advisor Advanced ATS 000A Series Installation And Programming Manual page 160

Condition
8.4.2.3 Zone fault
8.4.2.4 Zone tamper
8.4.2.5 Interconnection fault
8.4.2.6 Mains fault
8.4.2.7 Battery fault
8.4.2.8 FTC (Failed to Communicate)
8.4.2.9 Siren fault
8.4.2.10 Zone technical
8.4.2.11 Keypad fault
8.4.2.12 Expander fault
8.4.2.13 Comms fault
8.4.2.14 Engineer reset
8.4.2.15 Siren tamper
8.4.3 Forced set
3 Forced set
>Off<
The Forced set option enables the forced set feature. The forced set options are
configured below.
Forced set is an option where active zones can automatically be inhibited when
setting an area.
Note: This option should be used with care. Users may not be aware which
zones are inhibited.
8.4.4 Forced set options
4 Forced set opt
>Inh unset<
The Forced set options menu defines when the forced set is possible. The
following options are available.
Table 35: Forced set options
Option
Inhibit till unset
Inhibit exit
Inhibit close
150
Description
Intrusion detector fault
Tamper in zone
A critical error caused by communication trouble
between internal panel components
Mains fault, including external fault
Battery fault, including external fault
Reporting attempts are failed
Siren output fault
An alarm in the technical zone
A fault reported by keypad
A fault reported by remote expander
All transmission paths are down (no communication)
Engineer reset requirement
Siren tamper active
Description
Zone is inhibited until the area is unset.
Zone is inhibited until the exit time expires.
Zone is inhibited until its state changes to normal.
Advisor Advanced ATSx000A(-IP) Installation and Programming Manual