System Options; Timer Options - Interlogix Advisor Advanced ATS 000A Series Installation And Programming Manual

System options

8 System option menu
1>Timer menu
2 Engineer opt
Use the System menu to program the global system options including timers.

Timer options

8.1 Timer menu
1>Time&date
2 Siren options
Use the Timer menu to program all system wide timers in this section.
Notes
•
Timers are accurate to ±1 of the value entered. So a timer set for 20 seconds,
ends somewhere between 19 and 21 seconds. Consequently, avoid using
values of 1 second or 1 minute.
•
If a timer is set to 0, that timer is not used.
8.1.1 Time and date
1>Time zone
UTC+1
The Time and date menu allows you to set the system time and date, as well as
set up daylight saving time.
The following options are available.
Table 31: Time and date menu options
Option
8.1.1.1 Time zone
8.1.1.2 Date
8.1.1.3 Time
8.1.1.4 DST start mth
8.1.1.5 DST start wk
8.1.1.6 DST end mth
8.1.1.7 DST end wk
8.1.1.8 Set correction
8.1.1.8.1 Time/7days
138
Note
The system time zone.
Date format is DD-MM-YYYY.
Time format is 24 hours.
The DST start month.
The DST start week. The available options are: 1st week, 2nd
week, 3rd week, 4th week, last week.
As above.
As above.
Allows configuring time correction if necessary.
This submenu allows setting the time correction that is performed
each 7 days of panel work.
Maximum value is 5 min 40 s. Positive value means the clock is set
forward, negative — backward.
Advisor Advanced ATSx000A(-IP) Installation and Programming Manual