Lcd Display Options - Interlogix Advisor Advanced ATS 000A Series Installation And Programming Manual

8.2.7 Remote configuration
7 Remote config
Yes
If the option is set to Yes, it is allowed to change panel settings remotely via
configuration software when the panel is set. Otherwise, the panel must be unset
prior to remote programming.

LCD display options

8.3 LCD display options
1>Arm display
Always
The LCD options menu contains options that can be set for LCDs and menus.
8.3.1 Armed display
1 Arm display
>Always<
If the Armed display mode is Always, the armed display activates after the
programmed idle time. The armed display timeout is programmed in "8.1.3.1
Armed display" (see page 140).
The armed display deactivates when performing any action that requires an
authorization with a valid user code or badge.
You can select one of the following armed display options:
Table 32: Armed display options
Option
8.3.1.1 Off
8.3.1.2 If set
8.3.1.3 Always
8.3.1.4 Without code
8.3.2 Custom message
2 Custom msg
>UTC F&S <
The Custom message menu allows you to define a keypad welcome message.
Advisor Advanced ATSx000A(-IP) Installation and Programming Manual
Description
Armed display is disabled.
Armed display activates only when the area is set. No status
information is displayed on keypad LCD and LEDs (except mains
LED and Alert message).
Armed display always activates. No status information is displayed
on keypad LCD and LEDs (except mains LED and Alert message).
Armed display always activates. No area LED is lit.
Note: This mode also allows you to deactivate the armed display
pressing the Clear key.
147