Wireless Device Programming; Learning Wireless Sensors - Interlogix Advisor Advanced ATS 000A Series Installation And Programming Manual

Wireless device programming

To add a wireless device, follow one of the following procedures.

Learning wireless sensors

There are two modes available for learning a wireless device, sequential and
manual.
Sequential mode
In sequential mode, you can quickly learn a range of wireless sensors.
To learn sensors in sequential mode:
1. Go to the "4.1.0 Add zone" menu described on page 95.
1>Expander 1
2 Expander 2
2. Select zone location.
Learn mode
>Sequential<
3. Choose Sequential mode and press Enter.
Input number
> 2<
4. Choose an input number.
Note: Depending on the hardware configuration, door/window and shock
sensors can require two wireless zones to report main sensor and auxiliary
input states. In this case, two unoccupied consecutive zones are required.
See "Two-zone RF sensors" on page 201 for more details.
INFO
Tamper RF 1
5. Activate the wireless device. See "Device activation" on page 202 for more
information about activation.
If an error occurs, the keypad shows an error message and beeps seven times.
Example:
ERROR
RF duplicate
The error can occur, for example, when you try to learn a device, which is
already programmed in the wireless expander.
If the device is programmed successfully, the keypad beeps twice.
Advisor Advanced ATSx000A(-IP) Installation and Programming Manual 197