Interlogix Advisor Advanced ATS 000A Series Installation And Programming Manual page 210

2. Select fob zone location.
Learn mode
>Sequential<
3. Choose Sequential mode and press Enter.
Input number
> <
4. Choose an input number.
INFO
Program fob 1
5. Press the programming key sequence to activate the fob. See "Device
activation" on page 202 for more information about activation.
If an error occurs, the keypad shows an error message and beeps seven times.
WARNING
ERROR
The error can occur, for example, when you try to learn a fob, which is already
programmed in the wireless expander.
If the fob is programmed successfully, the keypad shows an information
message and beeps once.
INFO
Fob learned
If there are more fobs to program, and there are fob inputs available in the
wireless expander, repeat learning another fob.
INFO
Program fob 2
To stop the learning process and exit the menu, press Clear.
Proceed with the fob configuration.
Manual mode
In manual mode, you can learn and configure a fob.
To learn a fob in manual mode:
1. Go to the "4.2.0 Add fob" menu described on page 108.
1>Expander 1
2 Expander 2
2. Select zone location.
Learn mode
>Manual<
3. Choose Manual mode and press Enter.
Input number
> <
200 Advisor Advanced ATSx000A(-IP) Installation and Programming Manual