Interlogix Advisor Advanced ATS 000A Series Installation And Programming Manual page 204

Type Description
Chime area Change a chime functionality status
in the area
Chime keypad Change a chime functionality status
on the keypad
Set without exit Immediate set (without exit time) [1] 1. Areas selection
Fire reset Reset fire detectors [1]
Show open zones Show open zones [1]
Active alarms Show zones in alarm state [1]
Active faults Show faulty zones [1]
Alarm memory Show acknowledged alarms [1]
Alarms to ACK Show unacknowledged alarms [1]
UG control Change user group privileges
Keypad control Change keypad options
Walk test Run walk test [1]
Output test Test outputs [1][4]
Test pic to CS Take a picture and send it to a
central station
Fire Raise a fire alarm
Medical alarm Raise a medical alarm
Show inhibited Show inhibited or isolated zones,
keypads, and expanders.
GSM credit Check GSM credit
[1] Depending on system settings, the function may require logging in of a user with the
appropriate privileges. See "2.2.1.n.3.9 Quick set" on page 72 for more details.
[2] Set and part set function start time is the time when the warning timer is started. The warning
time must be taken into account. See "5.n.4 Warning time" on page 114 for more details.
[3] The function is an entry to the appropriate user menu. See Advisor Advanced Manager
Manual for more details.
[4] The function requires logging in of the supervisor or the installer.
[5] The function requires logging in of the supervisor.
194
Available parameters
1. Areas selection
2. Status change: Clear, Set, or Toggle
1. Keypad selection
2. Status change: Clear, Set, or Toggle
2. User code requirement
1. Areas selection
1. User code requirement
1. User code requirement
1. User code requirement
1. User code requirement
None
1. UG identifier
2 and further - user group privilege.
Choose a privilege, and then change
it.
See "3.2.n.5 User group options" on
page 91 for more details.
1. Keypad identifier
2. State change: lock or unlock
1. Area selection
1. Output selection.
4 outputs can be assigned.
These outputs are switched on
simultaneously for the longest time
period configured in "8.1.2.1
Activation" on page 139.
2. User code requirement.
1. Camera
2. Central station
None
None
None
None
Advisor Advanced ATSx000A(-IP) Installation and Programming Manual