Interlogix Advisor Advanced ATS 000A Series Installation And Programming Manual page 208

If there are more wireless devices to program, and the consecutive wireless
zones are available in the wireless expander, repeat activating another wireless
device.
INFO
Tamper RF 2
To stop the learning process and exit the menu, press Clear.
If next zones are already occupied on the wireless expander, the learning
process is over.
Proceed with the zone configuration.
Manual mode
In manual mode, you can learn and configure a wireless sensor.
To learn a sensor in manual mode:
1. Go to the "4.1.0 Add zone" menu described on page 95.
1>Expander 1
2 Expander 2
2. Select zone location.
Learn mode
>Manual<
3. Choose Manual mode and press Enter.
Input number
> 2<
4. Enter the input number.
If the input is free, you are prompted to activate the wireless device.
Tamper RF 1
Press # for ID
5. Activate the device, or press Enter to enter the wireless device identifier
manually. See "Device activation" on page 202 for more information about
activation.
Sensor ID
>
Note: Learning a wireless PIR camera by entering its identifier is not
supported.
The sensor ID is printed on a barcode sticker on the sensor box in the
following format: "Tx H<nnnnnnn>". For example, "Tx H103EB2B" mark
identifies a sensor with the ID 103EB2B. See also "4.1.n.7.1 Sensor ID" on
page 105 for more details on sensor identification.
198
<
Advisor Advanced ATSx000A(-IP) Installation and Programming Manual