Wireless Specific Options - Interlogix Advisor Advanced ATS 000A Series Installation And Programming Manual

2.2.2.n.5 Expander menu
5>Expander menu
>>>
The menu provides an access to the programming menu built-in to the expander.
For more information, see the appropriate expander manual.
Note: This menu is not available in wireless expanders ATS1235 with firmware
version 1.13 and newer.
2.2.2.n.6 Delete expander
6 Delete exp.
>Cancel<
Use the Delete expander command to remove an expander. Press Enter, select
OK and press Enter again. The expander is deleted.
Note: Before removing an expander, you should delete any outputs or condition
filters connected to the expander.

Wireless specific options

2.2.2.n.4.4 Supervision
1>Short superv.
20
The supervision is used to disable arming if the wireless expander does not
receive a supervision message from a sensor within the short supervision time.
A programmable supervision function checks the state of the devices in the field.
The supervision timers in the sensors are "dithered" by a small time so that
transmissions occur on a random basis with the effect of minimizing collisions in
larger installations.
Notes
• Two- and four-button fobs don't transmit supervision signals
•
Supervision time cannot be set for individual sensors, only for individual
wireless expanders
2.2.2.n.4.4.1 Short superv.
1 Short superv.
>20<
Short supervision is used to disable arming if the wireless expander does not
receive a supervision message from a sensor within the short supervision time.
The allowed range is 20 to 1920 minutes.
Advisor Advanced ATSx000A(-IP) Installation and Programming Manual 77