Interlogix Advisor Advanced ATS 000A Series Installation And Programming Manual page 161

8.4.5 Pending alarms
5 Pending alarms
>Enable<
If set to Enable, the Pending alarms option requires all alarms and faults to be
acknowledged.
Enable EN Gr3 is equal to Enable except that faults and tampers can only be
acknowledged by level 3 user (installer).
When disabled, it does not require alarm acknowledgement. During unsetting or
resetting the area, the alarm is acknowledged automatically. However, each
alarm and fault is shown 3 times on the keypad screen.
8.4.6 AS fault retry
6 AS fault retry
>15 minutes<
The Autoset retry on system faults option defines if and when the system repeats
an attempt to set automatically in if a system fault has made an autoset
impossible. The following options are available:
•
Off
•
15 minutes
•
30 minutes
•
1 hour
•
2 hours
•
3 hours
•
4 hours
See "Autoset" on page 196 for more details.
8.4.7 AS user retry
6 AS user retry
>15 minutes<
The Autoset user retry option defines a time for which a normal user can
postpone an autoset. The following options are available:
•
Disabled (autoset postponing is not allowed)
•
15 minutes
•
30 minutes
•
1 hour
•
2 hours
•
3 hours
•
4 hours
See "Autoset" on page 196 for more details.
The user must have a privilege for full setting to be allowed to postpone the
autoset. See "3.2.n.5 User group options" on page 91 for more details.
Advisor Advanced ATSx000A(-IP) Installation and Programming Manual 151