Interlogix Advisor Advanced ATS 000A Series Installation And Programming Manual page 228

Group Event
EXITFAULT
RTS
SETOK
SETFAULT
UNSETOK
ALARMACK
FIRERESET
WALK
WALKZNACTV
A-ALARM
B-ALARM
ISIREN
ESIREN
STROBE
BUZZER
AMRESET
PARTSET2
AS WARNING
AUTO SET
218
# Event description
60 Exit fault
61 Ready To Set
62 Area set OK
63 Area set failed
64 Area unset OK
65 Alarms to ACK
66 Fire reset
67 Walk test
68 Walk test zone
active
69 A-Alarm
70 B-Alarm
71 Internal siren
72 External siren
73 Strobe output
74 Buzzer output
75 AM reset
76 Area part set 2
77 Autoset warning
78 Autoset
Advisor Advanced ATSx000A(-IP) Installation and Programming Manual
Notes
Alarm detected during exit state
before changing to part or full
set state
Active when all configured RTS
conditions are valid
Active for 2 s when area set
successfully
Active during 30 s after
unsuccessful area setting
Active for 2 sec when area has
been unset
Alarms present waiting for
acknowledge
For FIRE zone, event active for
10 s after fire alarm
acknowledge (also inhibits fire
zone for 15 s). Also active for 10
s during fire zone walk test
User/Installer Walk test is active
Zone in walk test is activated
A-alarm active (unconfirmed
alarm), reset after unset or
expiration of AB timer and no B-
alarm.
B-alarm active (confirmed
alarm). Reset after unset
Internal siren. Activated on
alarm during the internal siren
time. Activation may be delayed
by Siren delay time.
Can be retriggered by next
alarm.
External siren. Activated on
alarm during the external siren
time. Activation may be delayed
by Siren delay time.
This flag can not be retriggered.
Strobe output. Activated by
alarm during Set. Deactivated
after unset.
Buzzer output flag
Activated during set procedure
to reset AM detectors
Area is in part set 2 state.
Area in warning state prior to
autoset
Autoset procedure is in progress