Mazda CX-9 Grand Touring 2009 Manual page 1586

1. When working on the left side of the vehicle, remove the wiper arm (LH). (See WINDSHIELD WIPER
MOTOR REMOVAL/INSTALLATION .)
2. When working on the left side of the vehicle, partially peel back the cowl grille (LH).
3. When working on the right side of the vehicle, partially peel back the cowl grille (RH).
4. Remove the front fender molding. (See COWL GRILLE REMOVAL/INSTALLATION .)
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.
7. Inspect for front wheel alignment, and adjust it as necessary. (See FRONT WHEEL ALIGNMENT .)
Fig. 2: Identifying ABS-Wheel-Speed Sensor, Brake Hose Clip, Cap, Nut & Torque Specifications
Courtesy of MAZDA MOTORS CORP.
FRONT SHOCK ABSORBER AND COIL SPRING REMOVAL NOTE
1. Make a mark on the body aligning the identification mark on the mounting rubber before removing the
front shock absorber and coil spring.
2008 Mazda CX-9 Grand Touring
2008 SUSPENSION Front Suspension - Mazda CX-9
mistake while servicing the vehicle.