Mazda CX-9 Grand Touring 2009 Manual page 1138

2008 ENGINE PERFORMANCE On-Board Diagnostic (MZI-3.7) - Mazda CX-9
and/or on-line repair information
availability.
Is any related Service Bulletins
available?
VERIFY TROUBLESHOOTING OF
DTC P0610 HAS BEEN COMPLETED
Verify that all disconnected
connectors are reconnected.
Turn the ignition switch to the ON
position (Engine off).
Clear the DTC from the PCM
3
memory using the M-MDS.
Perform the "KOEO and KOER self-
test". (See KOEO/KOER SELF
TEST [MZI-3.7].)
Retrieve DTCs using the M-MDS.
Is the PENDING CODE for this DTC
present?
VERIFY AFTER REPAIR
PROCEDURE
Perform the "After Repair
4
Procedure". (See AFTER REPAIR
PROCEDURE [MZI-3.7].)
Are any DTCs present?
DTC P061B [MZI-3.7]
DTC P061B (MZI-3.7) DETECTION CONDITIONS AND POSSIBLE CAUSES
DTC P061B Internal control module torque calculation performance
DETECTION
CONDITION
POSSIBLE
CAUSE
DIAGNOSTIC PROCEDURE
DTC P061B (MZI-3.7) DIAGNOSTIC PROCEDURE
2008 Mazda CX-9 Grand Touring
No
Yes
No
Yes
No
Indicates that a calculation error occurred in the PCM.
Connector or terminal malfunction
NOTE:
This DTC is an informational DTC and may be set in combination
with a number of other DTCs which are causing the FMEM.
Diagnose other DTCs first.
step.
Perform PCM reprograming using the M-MDS,
then go to next step.
Replace the PCM, then go to the next step. (See
PCM REMOVAL/INSTALLATION [MZI-
3.7] .)
Go to the next step.
Go to the applicable DTC inspection. (See DTC
TABLE [MZI-3.7].)
Troubleshooting completed.